-20%
Specifications
| Material | Grog |
|---|---|
| Appearance | Slightly granular |
| Colour | Beige |
| Length (overall) | 500 mm |
| Width (overall) | 200 mm |
| Thickness | 30 mm |
| Alumina content | 35 % |
| Maximum service temperature | 1200°C |
| Density | 2 g / cm³ |
| Quality | Pressed |
| Net weight | 6.2 kg |
| Manufacturer | Made in France |
| Origin | France |
| Food contact | Yes |
| Contains wood | No |
Dense refractory slab 500 x 200 x 30 mm - 30% alumina
Ideal for building or renovating the firebox of your masonry heater; with its large surface area and its resistance to high temperatures, this slab will greatly simplify building the firebox of your heat-storage stove and of any other wood-burning heating appliance.
Last items in stock
Volume discounts
| Quantity | Unit discount | You Save |
|---|---|---|
| 10 | 5% | €11.75 |
| 25 | 10% | €58.74 |
| 50 | 15% | €176.22 |
| 75 | 20% | €352.44 |
| 100 | 25% | €587.40 |
Related products:
Overview:
This slab can be used to build other parts of your firebox and also for the cladding of your heat-storage stove.
Thanks to its high alumina content, the product can be in contact with the flames and thus withstands high temperatures over long periods.
This slab also has excellent mechanical strength
Dry-pressed, this half-brick has a high density and a low dimensional tolerance of approximately 2 mm
Please note: the colour can vary from light beige to medium beige depending on the firing and its surface is slightly grainy.
Technical characteristics:
Bulk density: 2 g / cm³
Open porosity: 20%
Sag of 0.5% under load at 1200° C
Composition:
Al² O³: 25-30%
Ti O²: 1.4%
Fe² O³: 1.7%
Instructions for use:
It can be cut using a (wet) table saw or a disposable disc.
A diamond disc can be used, but it must be watered at the same time, otherwise it would wear out almost instantly.
